ReadyMadeRC
CASTLE CREATIONS PHOENIX EDGE 75 BRUSHLESS ESC, 34V MAX. W/BEC
| MIN | 2S LiPo MAX |
Helis:, 500 class, Fixed wing:, .40 - .52, Input voltage:, Max continuous amperage at full throttle:, 75 amps*, BEC voltage (voltage regulator for powering radio and sevos):, User selectable choice from 5 to 8.4 volt output, BEC output amperage:, 5 amp peak**, Width:, 2.0" (50.8mm), Length:, 2.8" (71.9mm), Height:, 0.9" (23.2mm), Weight w/wires:, 4.0 oz (113.4g), Weight w/o wires:, 2.5 oz (70.9g), Programmability:, Fully programmable Castle feature set using Castle Link USB adapter (coupon for free Castle Link USB adapter included in package) and freely downloadable Castle Link Windows software., Connectors:, Battery and motor connectors sold separately, Tools needed for installation:, Soldering iron and solder to attach bullets to motor wires and battery connector to power wires., *RC HOBBY APPLICATION RATING: 75 amps for the duration of a single 5,000 mAh battery pack with the ESC in contact with a 5 mph airflow of 25C (77F) or cooler air. Controller temperature must never exceed 100C (212F). Exceeding current or temperature ratings may damage components and may shorten the life of the ESC. Always verify system current draw at full-throttle. Decrease load or increase airflow to decrease the ESC’s operating temperature.,
With the debut of the Phoenix Edge series of ESCs ...ReadyMadeRC
TAROT 2 AXIS CAMERA GIMBAL FOR GOPRO HERO3, 3+ W/FREE CABLE
| 7. Supported receiver type | conventional/S-BUS/DSM2/DSMJ/DSMX receiver. |
| 8. Supported RC | PPM/PCM/2.4G. |
| 9. Operating supply | DC 7.4V~14.8V (Li-Po 3S is recommended) |
| 10. Operating current | 200mA-500mA (Depending on power supply voltage and motor power) |
| 11. Operating temperature | -15ºC~65ºC. |
| 12. CPU | Double 32bit ARM |
| 13. Sensor technology | 3-axis MEMS gyro and accelerometer. |
| 14. Max angular rate | 2000 º /sec. |
| 15. Max acceleration | 16g. |
| 16. Control frequency | 2000Hz |
| 17. Motor driver frequency | 20KHz (quiet and smooth) |
| 18. Control accuracy | 0.1° |
| 19. Control range | -45º~45º(roll), -135 º~90 º(tilt). |
| 20. Attitude arithmetic | BLDC gimbal dedicated brushless motor decoupled EKF algorithm. |
| 21. Aerial photography equipment | GOPRO Hero3. |
Note:, Modifications may be required to use HERO4, Parts included for the kit: 2 motors mounted onto the swing arms, gimbal controller board, mounting bracket with GoPro brace, 2 male to male servo cables (one with Y end), USB firmware updater connector and cable, 4 rubber dampeners and mounting bracket + hardware for the gimbal.,
FREE LIVE VIDEO OUT CABLE OPTION...YES, OUR CABLES WILL WORK ...ReadyMadeRC
RMRC PARALLEL CHARGING BOARD - 35A XT-60
| Housing Material | ABS Fireproof Material |
| Balance Tap | JST-XH |
| Cell Count | 2-6s |
| Fuse | 40A (4 fuses) |
| Size | 152x76x17.5mm |
| Maximum continuous current | 25A |
| Maximum current for short term | 35A (10 Minutes Max) |
Features:, , Specifications:, , NOTE:, Please follow all precautions included in manual before using this board for parallel charging. Not following these directions may result in fire and damages. Ready Made RC, LLC is not responsible for damaged batteries or property.,
Introducing the ReadyMadeRC Parallel Charging Board! The RMRC ParaBoard is ...ReadyMadeRC
RMRC PARALLEL CHARGING BOARD - 35A T-PLUG
| Housing Material | ABS Fireproof Material |
| Balance Tap | JST-XH |
| Cell Count | 2-6s |
| Fuse | 40A (4 fuses) |
| Size | 152x76x17.5mm |
| Maximum continuous current | 25A |
| Maximum current for short term | 35A (10 Minutes Max) |
Features:, , Specifications:, , NOTE:, Please follow all precautions included in manual before using this board for parallel charging. Not following these directions may result in fire and damages. Ready Made RC, LLC is not responsible for damaged batteries or property.,
Introducing the ReadyMadeRC Parallel Charging Board! The RMRC ParaBoard is ...ReadyMadeRC
3DR - DIY QUAD KIT
Important notes: This kit does not include an RC receiver and transmitter, battery, or battery charger. Please be advised that this kit does not include all the components necessary to connect a Tarot gimbal to the Quad. If you plan to use the, Kit includes:, , Telemetry Radios: Don't forget to add a telemetry radio set below in the appropriate radio frequency for your country. Select,
Build a 2014 Quad with this do-it-yourself kit! The 2014 ...ReadyMadeRC
RCA TO SERVO CONNECTOR ADAPTER CABLE FOR OSD EXPANDER
,
Useful if your video equipment uses RCA plugs. Two are ...ReadyMadeRC
OSD PRO PKG WITH 100A ELOGGER/WIRE LEADS AND GPS
| The plane icon labeled “RADAR” above serves two purposes | the direction the icon is pointing indicates your present course. |
| For example, you can program the OSD Pro to periodically update you on altitude once a minute | “Altitude 3-9-1 Feet”. |
Here are some examples:, , And, the location of the icon on the screen provides a synthetic map, similar to RADAR:, the center of the screen marks the takeoff point, in a "bird's eye" view, and the plane icon moves around the screen indicating your model’s location. The maximum distance and the “up” direction are configurable., The OSD Pro Expander has the following connections:, , The package includes:,
The OSD Pro is a powerful, modular, fully configurable Video/Audio ...ReadyMadeRC
OSD PRO PKG WITH 150A ELOGGER/WIRE LEADS AND GPS
| The plane icon labeled “RADAR” above serves two purposes | the direction the icon is pointing indicates your present course. |
| For example, you can program the OSD Pro to periodically update you on altitude once a minute | “Altitude 3-9-1 Feet”. |
Here are some examples:, •GPS Parameters (Distance to Home, Home Arrow, GPS Altitude, Ground Speed, Course, and more), And, the location of the icon on the screen provides a synthetic map, similar to RADAR:, the center of the screen marks the takeoff point, in a "bird's eye" view, and the plane icon moves around the screen indicating your model’s location. The maximum distance and the “up” direction are configurable., The OSD Pro Expander has the following connections:, •Connection to the eLogger or Data Recorder, The package includes:,
OSD Pro Pkg with 150A eLogger /Wire Leads and GPS ...ReadyMadeRC
IMMERSIONRC 2.4GHZ 500MW TX
| Weight | 22-grams.Size |
| Input Voltage Range | 6 – 16V. |
Notice: The use and operation of this product in the USA and many other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
Currently unavailable while ImmersionRC re-designs. 2.4GHz 500mW Tx Compact, Lightweight ...ReadyMadeRC
FATSHARK 2.4GHZ 10MW TX
| Input Voltage Range | 6 – 12V. |
Notice: The use and operation of this product in the USA and many other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
2.4GHz 10mW Tx Compact, Lightweight Package Camera Power Supply (5V) ...ReadyMadeRC
FATSHARK 2.4GHZ 100MW TX
| Input Voltage Range | 6 – 12V. |
Notice: The use and operation of this product in the USA and many other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
2.4GHz 100mW Tx Compact, Lightweight Package with enough power to ...ReadyMadeRC
EZUHF TRANSMITTER
| http | //fpvlab.com/forums/showthread....rade-procedure |
| http | //fpvlab.com/forums/showthread....r-installation |
| http | //fpvlab.com/forums/showthread....bind-procedure |
| http | //www.youtube.com/watch?v=gk46N8RKd2c&feature=channel_video_title |
Video describing how to connect to a JR radio:, , Notice: The use and operation of this product in the USA and many other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
The EzUHF transmitter is a true powerhouse with a wealth ...ReadyMadeRC
EZUHF TO EZOSD CONNECTOR CABLE
Ready Made....they way it's supposed to be! :), *Note: At the request of ImmersionRC, to prevent ground loop issues, there is no ground connection in this cable between the EZOSD and the EZUHF. If your grounds are not connected otherwise (as they normally would be through the other connections in the R/C system), you should ensure that you have all the grounds tied together.,
No soldering, crimping, or worrying! This cable will allow you ...ReadyMadeRC
EZUHF JR STYLE TRAINER CORD TX ADAPTER
Ready Made....they way it's supposed to be! :),
Now you can make the connection from your JR, Spektrum, ...ReadyMadeRC
EZUHF COMBO STARTER PACKAGE - LITE
| http | //fpvlab.com/forums/showthread....rade-procedure |
| http | //www.youtube.com/watch?v=gk46N8RKd2c&feature=channel_video_title |
Includes:, , Video describing how to connect to a JR radio if you want to make your own cable:, Notice: The use and operation of this product in the USA and many other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
This combo gets you all you need to have a ...